Required components :

Any arduino board(UNO/pro/mini/nano/duemilanove etc.),

power supply kit,

DHT11(temp. & humidity sensor),

IC DS1307(Real Time Clock),

Crystal 32.768kHz,

3V battery(for RTC back-up),

transformer 6V/200mA,

LCD 16x2,

SD/microSD/MMC card,

card holder,

diode bridge,

zener diode 5V,

capacitor 100uF,

10k resistance(1/4W) x 6,

10k variable resistance x 2,

toggle switch x 4

For achieving the value of ac voltage we need a 6V transformer. This transformer is not for the power supply of the project but it is used to measure ac voltage in terms of low secondary voltage as shown in the figure below. Secondary voltage is rectified, filtered and limited to a range of 5 Volts with a zener diode then it is applied to the analog pin 0(AN0/pin14) of the arduino board. 

arduino data measurement

For achieving the value of temperature we are using DHT11 sensor which provides a single data line. It is connected to analog pin 1(AN1/pin15) of the arduino board.

Add comment

Security code
Refresh

Comments  

ogled women
#2 ogled women 2016-11-27 13:25
I am in fact grateful to the owner of this website who has shared this fantastic post at at this place.
256 micro sd
#1 256 micro sd 2016-08-16 07:13
You've made some really good points there. I looked on the internet to find out more
about the issue and found most people will go along with your views on this site.
Amount:


1.png8.png2.png8.png2.png1.png
Visitors Today137
Visitors Yesterday132

  • Your IP Address : 172.18.210.22

1
Online

SG Templetes by Sameer Gupta