• sgprojects.co.in.jpg
  • Slide_Show_1.jpg
  • Thermal_power_plant.jpg

Thermal Power Plant Performance

The performance of any thermal power plant depends on so many factors like coal quality, heat rate, cycle efficiency, design etc. The efficiency of any plant is not constant always but reduces years of years. Generally a coal fired thermal power plant efficiently performs for 25 years if all the required maintainance is done time to time. 

Heat rate - “Heat rate is the heat required to generate one unit of electrical energy.” Heat rate in a thermal power plant is measure constitute for its thermal efficiency. The plant output should be higher with minimum heat requirement so we can say that the heat rate must be as low as possible.

                        The property of heat generation by fuel/coal depends on the calorific value. Also the CV(Calorific Value) depends on the elemental and non-elemental composition of coal. The analysis of coal composition are divided into two categories:

  1. Proximate analysis – In this analysis non-elemental composition are calculated. The non-elemental composition are fixed carbon, volatile matter, moisture and ash contents.
  2. Ultimate analysis – In this analysis elemental composition are calculated. The elemental composition are carbon(C), hydrogen(H), sulphur(S), nitrogen(N), oxygen(O), phosphorus(P), chlorine(Cl) etc.

Grading of coal is the measurement of heat content of the coal. It is measured in calorific value for each kilogram of coal weight.

Grade

Calorific Value (kCal/kg)

A

> 6200

B

5601 – 6200

C

4941 – 5600

D

4201 – 4940

E

3361 – 4200

F

2401 – 3360

G

1301 – 2400

Below ‘G’ grade coal are generally not used in any power plant to maintain the efficiency. High grade coals are generally mixed and blended with low grade coal. Before using the coal, it is passed from coal washery system where lot of waste substances of coal are removed by washing.

In a thermal power plant, unit's heat rate is required to power the turbine but practically it is not possible because heat loss occured in most of the parts like turbine extraction, vents, drains, tubes and a major part of heat is consumed in condenser side. Hence unit heat rate can never be equalize turbine heat rate.

Let's find out which formula that can be used to calculate the terms like heat rate, calorific values, efficiency etc. Then we'ill do some calculation on all these.

We know that Efficiency  η = output/input

   Efficiency  η = THR/UHR                 where    THR = turbine heat rate and UHR = unit heat rate

UHR (Q x CV)/MW           where    Q = coal flow rate, CV = calorific value and MW = plant output in MW

  GCV is calculated by Dulong’s formula,           GCV = (33820 x C) + 144000( H – O/8) + (9.204 x S)

Add comment

Security code
Refresh

Amount:


1.png8.png2.png8.png2.png1.png
Visitors Today137
Visitors Yesterday132

  • Your IP Address : 172.18.210.22

1
Online

SG Templetes by Sameer Gupta