Your Name LED Flashing Board

If you always want to show some special flashing effect of your name then this one project is only for you. Here I made the LED board for flashing a name “MANAH” with a cheap PIC microcontroller based circuit so that this project prepared for a low cost but highly effective.

Parts List:

  • Microcontroller PIC16F675
  • NPN Transistor TIP120/TIP122  X 5
  • LEDs
  • Resistor 1kΩ X5
  • Resistor 220Ω X5
  • Capacitor 220μF/16V
  • 8-Pin IC base
  • SMPS Board for DC 5V power supply
  • Any suitable Programmer like PICkit2/PICkit3.

For the word  ‘MANAH’ it is a 5-channel based circuit and for each I used approximately 100 LEDs per channel but in the circuit, only 3-3 LEDs per channel are shown for reducing the image size.

 

If your name is of different size then you just need to edit the program written with a compiler “Mikro C for PIC” and download the complete code from here. Finally burn the generated HEX code to the to the microcontroller using a suitable PIC programmer like PICkit.

Watch the video to know how it’s made:

Leave a Reply

Your email address will not be published. Required fields are marked *